Mineral Granules Bitumen Membrane
Modified Bitumen Waterproof Membrane with mineral granules is a strong, resilient, non-woven polyester mat coated with flexible, polymer-modified asphalt and mineral granules that enhance its performance when exposed.
It is time-proven system that have been around for decades due to reliable performance.
Area of Application:
It is widely used in:
- Roofing solutions in the industry
- Subway, tunnel, highway, bridge and etc
Polyester
High elongation properties and tensile strength.
UV Resistance
Membrane is exposed to the sun, it must be resistant to UV rays
Torch Applied
Torch applied against the surface, Long life span due to its tightness
Environment Friendly
Developed in new and alternative technologies.
Data Sheet
Get a Quote
Product Details
Modified Bitumen Waterproof Membrane with mineral granules is a strong, resilient, non-woven polyester mat coated with flexible, polymer-modified asphalt and mineral granules that enhance its performance when exposed.
-
Weidun Waterproof has a full line of Modified Bitumen Waterproof Membrane with mineral granules.
-
Due to its elongation characteristics, a resilient polyester mat core allows it to resist splits and tears.
-
Customizable width 2.2 meters.
-
Suitable for exposed roofs.
-
Available guarantee of up to 20 years.
Application:
They were widely used in roofing solutions in the industry, subways, tunnels, highways, bridges and etc.
How TO USE
The construction process of Mineral Granules Bitumen Membrane can be described as follows:
Surface preparation: The waterproof surface should be cleaned of debris and leveled. Any cracks or voids in the surface should be repaired before the membrane is installed.
Priming: A layer of primer should be applied to the prepared surface. The primer helps to improve the adhesion between the membrane and the substrate.
Cutting and positioning: The membrane is unrolled and cut to the appropriate length. It is then positioned on the surface to be waterproofed. Overlapping seams are necessary, and the manufacturer’s recommended overlap should be followed.
Heating and bonding: The membrane is then heated using a propane torch or hot air gun until the modified bitumen on the bottom of the membrane softens. This allows the membrane to bond to the prepared surface. Care should be taken to avoid overheating, which can cause the membrane to melt or shrink.
Sealing: The seams and edges of the membrane are sealed using a hot air gun or propane torch to melt the modified bitumen on the edges of the membrane. This helps to create a continuous and waterproof surface.
Protection layer: Finally, a protection layer such as gravel or insulation board is installed over the membrane to protect it from damage and weathering.
The mineral Granules Bitumen Membrane installation process involves surface preparation, priming, cutting and positioning, heating and bonding, sealing, and installing a protective layer. Careful attention to each step is necessary to ensure a high-quality, long-lasting waterproofing system.