
Weidun® 005 TPO Roofing Membrane
Heat-welded single-ply membrane with a reflective surface for commercial roofs.
Send Inquiry Now

This membrane is laid before the structural concrete is poured. Its sanded surface faces upward, so fresh concrete bonds to it as it cures, creating a fully adhered layer that stops water travelling between the membrane and the structure.
Pre-applied sheet that bonds to fresh concrete for basements and foundations.
Heat, humidity and heavy seasonal rain put constant pressure on below-grade structures.
A fully bonded barrier suits foundations, basements, utility tunnels and transport projects where groundwater must be controlled.

95%
Elongation
600%
Measured Performance
Key facts for contractors, engineers, distributors and buyers choosing a below-grade system.

A self-adhesive sheet laid before the concrete is poured. As the concrete cures, it bonds to the membrane and forms a fully adhered layer.
Basements, foundations, lift pits, tunnels and other below-grade structures.
Lay the sheets sanded side up, seal the laps, fix the rebar and pour the concrete.
We have decades of manufacturing experience, with products tested to international standards and exported to many countries. OEM support helps partners build their own brand locally.
The membrane forms a skin-type layer rather than a loose sheet. If it is damaged, water stays confined to that point instead of travelling under the structure.

Accommodates movement while keeping the layer continuous.
Protects the layer during foot traffic and rebar installation.
Performs reliably under demanding below-grade conditions.
Full adhesion blocks water paths and confines any leak.

Laid beneath the concrete with its adhesive side up. As the concrete cures, the two bond chemically and mechanically.

A very low-permeability liner. Large areas are covered by welding adjacent sheets together on site.
| Primary Goal | Fully bonded structural waterproofing | Low-permeability containment lining |
|---|---|---|
| System interface | Bonds to subsequently poured concrete | Sheets welded into one lining |
| Installation | Laid sanded side up; laps sealed | Adjacent sheets heat-welded |
| Water control | Full adhesion stops water migrating | Very low permeability |
| Typical use | Below-grade concrete structures | Containment and lining systems |
Both systems keep water out, but they are designed for different jobs.
Choose the pre-applied membrane when you need full bonding to a below-grade concrete structure. Choose a geomembrane when the project needs a very low-permeability lining welded on site.

Unroll the membrane over the levelled base, sanded side up, and seal every lap to form a continuous barrier.
Build the reinforcement directly over the membrane on spacers. The tough surface resists damage from site traffic.
Pour and vibrate the concrete. As it cures, it bonds to the membrane and forms a fully adhered system.






Our range covers the technical needs of underground construction, water-retaining structures and industrial buildings.

Heat-welded single-ply membrane with a reflective surface for commercial roofs.
Send Inquiry Now
Pre-applied sheet that bonds to fresh concrete for basements and foundations.
Send Inquiry Now
Flexible heat-welded membrane for roofs, tunnels and water-retaining structures.
Send Inquiry Now
Tough, flexible sheet widely used for tunnel and underground linings.
Send Inquiry NowIt stops water travelling between the membrane and the structure, so any damage stays local.
Yes. The surface is designed to take normal site traffic.
No flame is needed, and in most cases no separate protection layer.
Yes. We offer OEM branding, roll sizes and packaging.
It depends on order size and destination. Ask us for a schedule.


Choose pre-applied waterproofing backed by decades of manufacturing experience and an experienced technical team.